SCHOTT ACE 1 / DCR Series Halogen Light Source Replacement Socket

This SCHOTT replacement socket is intended for ACE 1 and DCR Series halogen light sources where the original socket has become worn, heat-stressed, loose, or intermittent—causing lamp flicker, unstable output, or difficulty maintaining consistent illumination. Replacing the socket can restore proper lamp seating and electrical contact so the illuminator performs predictably again.

Fitment note: This socket is for SCHOTT ACE 1 / DCR Series halogen light sources. If you are using KL Series LED or other SCHOTT families, this is not the correct part.

Specifications:

Manufacturer: SCHOTT
Product: ACE 1 / DCR Series Halogen Light Source Replacement Socket
Compatibility: SCHOTT ACE 1 and DCR Series halogen light sources
Function: Replacement lamp socket (restores proper lamp seating/contact)
Shipping: Calculated at checkout

When a socket replacement is the right fix

Intermittent lamp output: flicker that persists after a new bulb is installed
Loose lamp seating: lamp does not “feel” secure or consistently seats the same way
Heat-related wear: discoloration or brittleness near the lamp interface (inspection dependent)
Recurring premature lamp issues: frequent failures that correlate with poor contact

Related SCHOTT Items

About the Manufacturer:

SCHOTT is a multinational technology group known for specialty glass, advanced materials, and precision components used in microscopy, industrial inspection, electronics, and life-science workflows. In illumination systems, SCHOTT supports long service life by offering replacement parts and modular components that help teams maintain consistent performance over time.

Notes: Always follow your equipment service manual and site safety procedures. Confirm the exact SCHOTT light-source family (ACE/DCR vs KL) before ordering to avoid compatibility issues.

For application support, call 800-443-7101 or email Sales@SOSsupply.com.

Product page updated: Feb. 7, 2026 (SOS Technical Staff)

© 2026 SOSCleanroom.com. All rights reserved.

The Technical Vault: ACE 1 / DCR Halogen Replacement Socket

Vault purpose: What the socket fixes, what symptoms point to socket wear (vs a bulb), and how to avoid common service mistakes in halogen illuminators.

1) What this part is (and what it is not)

This product is a replacement lamp socket for SCHOTT ACE 1 / DCR Series halogen light sources. It is not a light guide, not a power supply, and not a KL-series component.

2) What problems a socket replacement solves

Intermittent output: unstable contact can cause flicker or cut-outs even with a new bulb.
Repeatability drift: inconsistent seating can shift output and alignment from change to change.
Heat-stress wear: halogen systems run hot; socket materials and contact tension can degrade over time.

3) Quick diagnostic logic (bulb vs socket)

If a fresh bulb fixes the issue: you likely had end-of-life lamp behavior.
If flicker persists with a fresh bulb: suspect socket contact, wiring, or internal thermal protection (manual-dependent).
If output changes with vibration/movement: socket contact tension or seating is a common root cause.

Safety note: Halogen sources can remain hot after power-off. Allow full cool-down and follow the manufacturer’s service instructions before handling internal parts.

4) Compatibility guardrail (ACE/DCR vs KL)

This part is specified for ACE 1 / DCR Series halogen. If your station uses KL Series LED sources (KL 300 / KL 1600 / KL 2500), you need KL-series parts and accessories instead.